Westcott FJ200 Strobe - FJ200 Exposure Modes; TTL Mode Operation; Manual Mode Operation

4. Rotate the reflector or modifier counterclockwise until the four square mounting blocks align with
the adapter openings and gently pull the modifier away from the strobe to remove.
Attaching an Umbrella-Based Modifier
1. Ensure the strobe is turned OFF and has cooled for a minimum of five minutes before
proceeding.
2. Grasp the umbrella’s shaft and slide into the strobe’s umbrella receptacle located on the tilter
bracket.
3. Slide the umbrella into the desired position.
NOTE: Due to the compact design of the FJ200, the removable tilter bracket is not equipped with an
umbrella tension screw. When using umbrella based modifiers, avoid tilting the FJ200 at an angle that
may cause the modifier to slide out of the bracket, resulting in potential damage to the product,
individuals, and/or the surroundings.
Removing an Umbrella Based Modifier
1. Ensure the strobe is turned OFF and has cooled for a minimum of five minutes before
proceeding.
2. Grasp the umbrella’s shaft and gently slide the umbrella out of the FJ200 umbrella receptacle.
NOTE:
● Never force entry or removal of modifiers and/or umbrellas.
● Use caution during the removal of modifiers to not damage the flash tube.
● Octagonal and larger umbrella shafts greater than 8mm will not fit into the FJ200 umbrella
receptacle.
FJ200 Strobe: FJ Wireless Communication
Fully maximize the performance and features of the FJ200 by using the FJ-X2m Wireless Radio Trigger
or FJ80 Universal Speedlight for dedicated wireless communication.
FJ200 Strobe: Exposure Modes
Enabling ‘TTL’ Mode Operation
NOTE: Requires FJ2-Xm Wireless Trigger, FJ80 Universal Speedlight, or compatible wireless transmitter
for proper operation.
1. Quick press the center Control Dial once to enter the Settings menu.
2. Rotate the Control Dial until Mode is selected within the thin white box.
3. Once selected, quickly press the Control Knob until the thin box turns blue.
11