Westcott FJ200 Strobe - FJ200 Settings and Battery; Settings Options Overview; Battery Performance and Care

2. Rotate the Control Dial until SYNC is selected with the thin box.
3. Once selected, quickly press the Control Knob until the thin white box turns blue.
4. Rotate the Control Dial until FRE sync is selected.
5. Engage FRE sync by quickly pressing the Control Dial or by pressing the Return | Model button
once.
6. Rotate the Control Dial to make further changes in the Settings menu or press the Return |
Model again to return to the main control screen.
Freeze Sync Flash Durations
● Flash Duration (t0.1)
○ Normal: 1/260~1/2600s
○ Freeze: 1/260~1/7000s
● Flash Duration (t0.5)
○ Normal: 1/800~1/8000s
○ Freeze: 1/800~1/20000s
FJ200 Strobe: Advanced Functions
Continuous Capture
The FJ200’s rapid recycling times allow for rapid bursts up to 20fps (frames per second).
NOTE:
1. Available in Manual Mode Only. See section “Enabling ‘Manual’ Mode Operation.”
2. 20fps requires Power Output ≤ 4.0 and camera model dependent.
FJ200: Settings Menu
Navigating the Settings Menu
1. Quick press the center Control Dial to enter the Settings menu.
2. Navigate the Settings menu by rotating the Control Dial to move the thin box to the desired
setting.
3. Once the setting is highlighted with the box, quickly press the Control Dial to highlight the
selection in blue and adjust the options for that setting.
4. Rotate the Control Dial to select the desired option.
5. Enable the settings option by quickly pressing the center Control Dial or by pressing the Return |
Model button once.
6. Repeat steps 2-5 to make further adjustments or press the Return | Model again to return to the
main control screen.
14