Westcott FJ200 Strobe - FJ200 Sync Functions; Normal and HSS Sync

To Next Page

To Previous Page

4. Rotate the Control Dial until TTL mode is selected. [Note: If the strobe does not advance to TTL

selection, then ensure that “Wireless” is turned ON in the Settings menu.]

5. Engage the TTL setting by quickly pressing the center Control Dial or by pressing the Return |

Model button once.

6. Rotate the Control Dial to make further changes in the Settings menu or press the Return |

Model again to return to the main control screen.

7. TTL mode is now enabled. While in TTL mode, rotate the Control Dial to adjust the Flash

Exposure Compensation (FEC) of the strobe between -3.0 and +3.0 ( ±0.1 adjustments).

NOTE: The Flash Exposure Compensation selected on the FJ200 strobe screen is independent of the

Flash Exposure Compensation controlled by the FJ-X2m Wireless Radio Trigger or FJ80 Universal

Speedlight.

Enabling ‘Manual’ Mode Operation

1. Quick press the center Control Dial once to enter the Settings menu.

2. Rotate the Control Dial until Mode is selected within the thin white box.

3. Once selected, quickly press the Control Knob until the thin box turns blue.

4. Rotate the center Control Dial until M mode is selected.

5. Engage Manual mode [M] by quickly pressing the center Control Dial or by pressing the Return |

Model button once.

6. Rotate the Control Dial to make further changes in the Settings menu or press the Return |

Model again to return to the main control screen.

7. Manual mode is now enabled. While in Manual mode, rotate the Control Dial to adjust the

strobe’s output between 1.0 and 9.0.

a. Adjust the strobe output in ±0.1 & 1.0 increments by long-pressing the Control Dial while

on the main screen.

NOTE: Manual functionality does not require the use of a compatible wireless triggering device. Manual

mode can be achieved with wired, optical, or wireless receivers limited to manual ﬂash triggering only.

Group SLP (Sleep) Mode

FJ Wireless Flashes can be placed into SLP (sleep) mode from any FJ transmitter disabling the unit’s

ability to ﬂash while other ﬂash groups continue operating normally.

1. Determine the Group [A-F] that the FJ Wireless Flash Device is assigned to.

2. Press the corresponding FJ-X2m’s Group Selection Button or FJ80’s MODE Function icon [HOST

mode] continuously until SLP (sleep) appears on the transmitter and ﬂash next to the Group. Note

that any ﬂash units assigned to this Group will also enter into SLP mode.

3. Exit the SLP mode by continually pressing the corresponding FJ-X2m’s Group Selection Button or

FJ80’s MODE Function icon [HOST mode] until the screen displays TTL or M.

NOTE: It’s important that the Exposure Mode type is updated from the transmitter, otherwise, the ﬂash

unit(s) will re-enter SLP mode when the next transmission signal is received from an FJ transmitter.