Settings Options
● Mode Options: [TTL, M]
● SYNC Options: [NOR, HSS, FRE]
● Channel Options: [AU, 01-31]
● Group Options: [A, B, C, D, E, F, G, H, I, J, L, O, P, Q, S, U]
● Wireless Options: [OFF, TTL-ALL, RT/ID]
● RT ID# Options: [00-99]
● Optical Options: [OFF, ON]
● Beep Options: [OFF, ON]
● TTL->M Options: [OFF, ON]
● Auto-Off Options: [OFF, 10, 30]
● Screen Options: [MIN, MID, MAX]
● Factory Reset Options: [NO, YES]
NOTE: SYNC option FRE is only available when the Mode setting option is set to Manual [M].
NOTE: Optical option is only available when the Mode setting option is set to Manual [M].
NOTE: Mode option TTL is only available when the Wireless setting option is set to TTL-ALL or RT/ID.
FJ200 Battery: Performance and Care
FJ200 Battery Performance
The FJ200 Lithium-Polymer Battery (14.8V 37Wh, 2500mAh) is capable of 450+ full-power flashes with
the modeling lamp disabled and screen brightness set to MIN.
FJ200 Charging & Life Expectancy
The average charge time is 2 hours from complete discharge. The FJ200 Lithium-Polymer Battery (14.8V
37Wh, 2500mAh) will achieve at least 300 complete charge cycles (@80% after 300). Continued usage
beyond the expected charge cycles will result in diminished performance and the ability to hold a
charge. Avoid charging and using the battery outside of the stated operating temperatures 50~113°F /
10~45°C as it will affect the overall performance of the battery and strobe. Preserve the battery’s
longevity by storing at roughly ~40% capacity at room temperature in a dry environment and recharge to
this capacity at least every three months when not being used.
FJ200 Strobe: Technical Specifications
Energy Range (Power Output)
9 f-stop (.8Ws to 200 Ws)
To Next Page
Loading...