WD-151E - WD-421E Rev. 00 (202310)
Installation instructions touch
31
4. Start the machine:
• Check the direction of rotation of the pumps
NB! If the direction of rotation is wrong, the phase must be inverted on the
incoming feed.
• Check that the overload switch on the feed cradle is functioning.
5. Lock the impulse arm and the photocell in the activated position:
• Run the machine continuously for 10 minutes. Check and adjust the tem-
perature and water flow
• Final rinsing (in accordance with the table in the manual)
• Intermediate rinsing (in accordance with the table in the manual)
• Pre-rinsing (in accordance with the table in the manual)
6. Run a number of washes complete with dishware and check:
• The basket is in the correct position after the photocell
• There are no water leaks
• The door switch works
• The limit switch is working
• Steam discharge from the machine
• The water temperatures are maintained
• The dishware is clean
N.B.: If the machine is equipped with detergent dosing, this function is
roughly set at the factory; contact your chemical supplier for a more precise
setting.
• The dishware is dry
N.B.: If the machine is equipped with drying agent dosing, this function is
roughly set at the factory; contact your chemical supplier for a more precise
setting.
7. Final check: Empty the machine, turn the machine off using the ON/OFF
button and then turn off the power at the main switch:
• Re-tighten all the connections on the circuit breakers and contactors
• Check that all the mini-switches and the motor cut-off switch are in the on
position.
• Display the quick guide supplied with the machine
8. Train and inform personnel concerning:
• Washing
• Care (daily, weekly and other frequencies)
• Recommendation for annual service
3.8 Documentation
For correct use and servicing, it is essential that the documentation accompany-
ing the machine is made available to personnel who will be using the machine.
The installation and user manual, which describes handling and care among oth-
er things, should be stored near the machine.
To Next Page
Loading...
