Wexiodisk WD-151E touch - Preparations Before Filling

WD-151E - WD-421E Rev. 00 (202310)
Operating instructions touch
35
4.1.2 Preparations before filling
Check:
• that the machine and removable parts have been cleaned. If not – clean
them!
• that there is no dirt in the wash arms (6) or rinse nozzles (9).
• that removable parts are correctly in place.
• the amount of detergent and drying agent.
• that the stopcock for the water to the machine is open.
• that the main switch (4) is in the ON position.
Remember:
• Ordinary washing-up liquid must not be used in the machine or for soaking.
Contact your detergent supplier regarding the choice of a suitable deter-
gent. Washing-up liquid causes a build-up of foam, produces poor wash re-
sults and can damage the machine.
• Steel wool must not be used for pre-treating the dishware.
• Only detergent and drying agent intended for industrial machines may be
used.
• Use the same make and type of detergent and drying agent.
Wash arms
The number of wash arms depends on the size of the machine and the washing
zone in which they are located in the machine.
305193
PRE-WASH WD-151E WD-211E WD-241E -WD-421E
-- 3 pcs
(2 pcs placed up and & 1 pcs down)
4 pcs.
CHEMICAL WASH WD-151E - WD-241E WD-331E WD-421E
4 pcs. 4 pcs / zone
(total 8 pcs)
4 pcs / zone
(total 12 pcs)