WD-4C Rev. 3.0 (201308)
Installation
13
1. Check:
• Water and drain connections
• That the machine is evenly balanced
• Detergent and drying agent
• Filters and level pipe are in place
• The overheating protection on the booster heater is set to zero
2. Filling the machine:
• Turn on main switch
• Close the door
• Turn on the 0/1 button
• Fill the machine with water as per the INSTRUCTIONS FOR USE
3. Start the machine:
• Check the pump's direction of rotation
NB! If the pump is rotation in the wrong direction, the phase must be invert-
ed on the lockable main switch.
• Empty the machine and refill
• Check the final rinse flow during filling
Note: If the flow is correct, the machine will fill in 1.5 min. The flow is regu-
lated by the built-in ball valve.
4. Check the setting of reference values:
• All the reference values are set to the recommended values on delivery.
• Check the temperatures
5. Run a number of washes complete with loads and check that:
• There are no water leaks
• The door breaker works
• The water temperatures are maintained
• The washed items are clean
• The washed items dry off
Note: The equipment for detergent and drying agent is roughly set at the
factory; contact your detergent supplier for a more precise setting.
6. Final check: Empty the machine and turn off the power using the main
switch.
• Re-tighten all connections on contactors and any circuit breakers
• Set all circuit breakers to ON position
• Put up the accompanying care instructions
7. Train dishwashing staff
To Next Page
Loading...
