Wexiodisk WD-4C - Preparations before Filling, Without Emptying Pump; Preparations before Filling, with Emptying Pump

WD-4C Rev. 3.0 (201308)
Directions for use
18
4.1.3 Preparations before filling, without emptying pump
Check:
• that the dishwasher and all removable components are clean and that
there is no dirt in the washing and rinsing arms’ nozzles (13, 14).
• that the rubber seal (10) is undamaged.
• that the shut-off cock for the water is open.
• the quantity of detergent and drying agent.
Washing-up liquid must not be used in the machine or for pre-treating items
(soaking, pre-washing, etc.) It causes foam to form and gives poorer washing re-
sults.
Assemble:
The drain filter (9), level pipe (11), pump filter (8), tank filters (7), cover plate (12).
The level pipe’s rubber seal (10) must be sealed against the bottom plate.
Close the door.
4.1.4 Preparations before filling, with emptying pump
Check:
• that the dishwasher and all removable components are clean and that
there is no dirt in the washing and rinsing arms’ nozzles (14, 15).
• that the rubber seal (11) is undamaged.
• that the shut-off cock for the water is open.
• the quantity of detergent and drying agent.
Washing-up liquid must not be used in the machine or for pre-treating items
(soaking, pre-washing, etc.) It causes foam to form and gives poorer washing re-
sults.
Assemble:
The drain filter (10), level pipe (12), pump filter (9), tank filters (8), cover plate (13).
The level pipe’s rubber seal (11) must be sealed against the bottom plate.
Close the door.