WD-4C Rev. 3.0 (201308)
Safety instructions
4
2.4 Detergent and drying agent
Only detergent and drying agent intended for industrial dishwashing machines
are to be used. Washing-up liquid must not be used in the machine or for pre-
treating items (soaking, pre-washing, etc.). Contact your detergent supplier re-
garding the selection of a suitable detergent.
Be aware of the risk of handling washing and drying agents. Protective gloves and
goggles should be used when handling machine dishwashing detergent. Read
the warning text on the detergent and drying agent containers as well as the reg-
ulations of the detergent supplier.
2.5 Operation
2.5.1 Hot water
The temperature of the washing and rinsing water is 60°C and 85°C. Do not open
the door until the washing and rinsing phase is finished.
2.5.2 Risk of crushing
Be careful when closing the door to avoid crush damage.
2.6 Cleaning the machine
The temperature of the water in the tank is approx. 60°C and contains detergent.
Be careful when emptying and cleaning the machine. Use protective gloves.
2.6.1 Cleaning with high-pressure washing
High-pressure washing must not be used for washing the inside or outside of the
machine.
In order to satisfy current requirements, electrical components of approved enclo-
sure classes are used. There is no enclosure class capable of withstanding high
pressure.
2.6.2 Outside the machine
Pressure washers and hoses must not be used to wash the outside of the ma-
chine. Water can penetrate into the electrical cabinet and the control panel and
damage the equipment, which may affect the safety of the machine.
To Next Page
Loading...
