Wexiodisk WD-4C - Filling the Machine, Without Emptying Pump; Filling the Machine, with Emptying Pump

WD-4C Rev. 3.0 (201308)
Directions for use
19
4.1.5 Filling the machine, without emptying pump
• Turn the knob (1) to position (3). The machine fills with water.
• The signal lamp (2) lights up green when the correct water level is reached.
• The process of heating the water to washing temperature starts. The heat-
ing time is dependent on the incoming water temperature. Before washing
starts, check the thermometer on the front of the machine to ensure that
the final rinse temperature has reached 85°C.
4.1.6 Filling the machine, with emptying pump
• Turn the knob (1) to position (3). The machine fills with water.
• The signal lamp (2) lights up green when the correct water level is reached.
• The process of heating the water to washing temperature starts. The heat-
ing time is dependent on the incoming water temperature. Before washing
starts, check the thermometer on the front of the machine to ensure that
the final rinse temperature has reached 85°C.