Battery Select Switch
e Battery Select switch is a 2-position slide switch that selects either Lead Acid/AGM or
Gel battery. In the Lead Acid/AGM position, the converter will output both Absorption
and Bulk Mode voltages.
With the Battery Select switch in the GEL position, the output will remain in Absorption
Mode. Bulk Mode is disabled to prevent damage to the GEL batteries.
If the above checks have been made but the converter output still reads 0.0 VDC, the
converter is not functioning properly.
9
Figure 5
GENERAL COMPLIANCE INFORMATION
Agency Listings
UL
e WF-68100 Series Converter-Chargers are UL-Listed, and cUL-Listed (Canadian).
FCC Compliance Class B
NOTE: is equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. ese limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. is equipment generates, uses, and can
radiate radio frequency energy, and if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation
of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
To Next Page
Loading...
Need help?
General
