Warning
Receiver battery installation method
Safety Prompts (Battery selection and installation)
Transmitter battery selection
Transmitter standard input voltage range 3.7V - 6V, the battery can select the following
configuration:
>Standard AA - 5 # NiMH / 1.2V rechargeable nickel-cadmium batteries, together use with
four standard battery box equipped by this product.
>Standard 1S - 4.2V Lithium Battery
Receiver battery selection
Transmitter battery installation method
Receiver standard input voltage range 4.8V - 12.6V, the battery can select the following
configuration:
>Four standard AA - Day 5 # NiMH / 1.2V rechargeable nickel-cadmium batteries.
>SC standard 5.0V output using the power supply for receiver.
As shown: the battery is connected to the connector, and then inserted into the socket inside
the battery compartment on the right side of the transmitter.
Any channel can be used as power input,
Connect with the third channel when powered by
ESC,changable by practical situation.
As shown: the battery and plug connection,
insert receiver.
Signal terminal
The positive electrode
The negative electrode
Positive and negative electrode
contacts errors will burn receiver.
4
To Next Page
Loading...
