This feature allows you to select the rocker’s mode of operation according to your own
operating habits and preferences.
Setting path: press the MENU key to boot, enter the "SYS SETTING" menu,
select "STICK SETTING".
Save parameters: select edit item with Arrow keys,
select stick mode with up and down keys,
press EXIT key to exit and save automatically.
Definition:
1 - aileron
2 - elevator
3 - throttle
4 - rudder
The importance of Failsafe :reduce the rate of injury when the aircraft lost control.
Advice: set failsafe data first before calibration or flight.
The information is automatically transferred to the receiver, you do not need to set at every
flight.
Steps:
1 Receiver power on ( linked )
2 Transmitter boot into FAIL SAFE settings menu, the channel data can be set as needed (when
RF off this function automatically shielded), after setting press the EXIT key to save the data.
*UP and DOWN keys: switch the channel; (+)(-) keys: switch hold and custom value;
Enter key: truncate all channel parameters in the condition of custom.
Recommended setting data:
1.Helicopter throttle set to 5% -10%, do not completely shut, otherwise the aircraft no power
directly fell to the ground, the rest of the channel set to steady flying.
2.Airplane / throttle is set to 0, the remaining channels can be set for a smooth flight,
because Airplane / glider no power can also be flat Steady decline authentic.
3.Car / boat setup is basically the same setup as airplane.
4.Multi-axis is similar to the helicopter, generally set to hover over the throttle position.
Fail-safe
ADVANCED
③PROG.MIX2
④PROG.MIX3
⑤FAIL SAFE
⑥CODING
THR
RUD
GEA
FLP
AUX1
Warning
Stick Settings
Model Settings
Setting: press the MENU key to boot, enter the "SYS SETTING" menu,
select "MODEL SELECTTING" and "MODEL SETTING",
select respectively 1 model of 10 models and model type.
Save: select with Arrow keys, confirm the option with Enter key,
power off according to the prompt, save directly.
8
To Next Page
Loading...
