Wfly WFT07 - 2.4 Ghz Receiver Instructions

Basic Function:1.match Code 2. 3.fail-safe 4 model Setting .stick Setting
coding finished...
light off
coding....
orange light flashing
Long press
SET key
Precaution
Steps
Verification Code
Match code
Product Configuration
B
a
t
t
e
ry b
o
x
W
F
R
07
S
Neck strap
1. Remote control and the receiver should within a short distance (less than 1m)
2. Remote control can not match code in the simulator mode (RF lights off)(Hold down the
MENU key to boot into coach / analog set)
3. NO other WFLY 2.4GHz systems matching nearby.
4. No high frequency high voltage interference sources nearby. (high-voltage wire, tower,
mobile base stations, etc.).
5. During coding, if the code needs to quit, please press the escape key to (Press to exit)
6. The matching finished, connection must be verified
1.The receiver on power,long press SET button, 3-4 seconds, slow flashing orange lights.
2.Transmitter enter the code menu: Boot → MENU → 15 Advanced Settings → 9 on the code
→ OK
3.The code is successful, the blue light transmitter, receiver lights off.
As shown:
1.connected to the steering gear and operate the remote control, synchronous operation
outputs corresponding servos description of the code successfully.
2.Turn off the remote control, the receiver red light; open the remote control, the receiver
lights off means succes.
Caution
ON
ONONON
7