EasyManuals Logo

Whale Gusher 30 Series User Manual

Whale Gusher 30 Series
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
Note: Annually at the end of the season, fully drain all water in the pipework and pump chamber. Whale® cannot
guarantee warranty if the system is not fully drained for winterising.
Service kits available: AK3051 (Full Spare Kit) and AS3095 (Spare Handle etc)
For installation or service advice please contact Whale® Customer Support:
Tel: +44 (0)28 9127 0531
Email: info@whalepumps.com
www.whalepumps.com
This product complies with all relevant European directives and standards. Please contact Whale® if further details
are required
Manufacturers Declaration
We hereby declare, under our sole responsibility, that the enclosed equipment complies the international standard
EN ISO 15083. Also approved by Lloyds (MSCA) and USCG for use in lifeboats and rescue boats or as an
emergency fire pump in accordance with BS ISO 18813 Sections 4.3.2.2 and 4.3.2.3.
Engineering Director
WHALE® and GUSHER® are registered trademarks of Munster Simms Engineering Limited, Bangor, Northern
Ireland trading as Whale and Whale Seaward Inc.
This Whale® product is covered by a 5 year warranty. Please see the enclosed document for details of our
Statement of Limited Warranty.
©Copyright Whale® 2014 - All rights reserved.
Whale’s policy is one of continuous improvement and we reserve the right to change specifications without prior
notice. Illustrations are for guidance purposes only. Please note that by contacting Whale® Support you will be
indicating your consent to receiving product updates, recall information, help guides and appropriate marketing
messages from us via post, email or telephone unless you indicated an objection to receiving such messages.
11. WINTERISING
10. TROUBLE SHOOTING
14. PATENTS AND TRADEMARKS
15. WARRANTY
Fails to prime
Inlet hose fault
Check inlet hose connection is airtight, free from blockages and does not
collapse during suction stroke
Diaphragm failure If damaged replace all rubber parts (Part No. AK3051)
Debris in the body
of the pump
May not prevent its operation, but should be removed to prevent
damage
Inlet and/or
outlet valve failure
Inspect and remove any debris. If damaged replace (Part No. AK3051)
USA Tel: 1 802 367 1091
USA Fax: 1 802 367 1095
Email USA: usasales@whalepumps.com
www.whalepumps.com
12. SERVICE SUPPORT DETAILS
13. DECLARATION OF CONFORMITY, STANDARDS AND APPROVALS
6

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Whale Gusher 30 Series and is the answer not in the manual?

Whale Gusher 30 Series Specifications

General IconGeneral
BrandWhale
ModelGusher 30 Series
CategoryWater Pump
LanguageEnglish

Related product manuals