Removal
Insert the removal tool into the gap between the bottom of the cap and the motor, hold the
motor up to lift and then remove the propeller.
Note:
Be sure to remove the propeller with a paddle removal tool. Do not remove it directly by
hand. Otherwise, it will damage the motor or cut your finger.
Do not get close to the rotating propeller and motor to avoid cuts.
Please use standard propellers. Do not mix different types of propellers.
Please check that the propeller is properly installed and fastened before each flight.
Make sure that each propeller is in good condition before each flight. If it is aged, damaged,
or deformed, please replace it before flying.
To Next Page
Loading...