1. Make sure that the power switch is set at the OFF position while making connections to and from the power amplifier
2. Connect all devices in the signal path and ensure that each connection is secure.
3. Set all level and gain controls to their minimum.
4. After powering up all other devices first, turn the power switch on the amplifier to the ‘ON’ position and verify that the
POWER LED is illuminated.
5. Turn the amplifier volume control up to the “7” setting. (This setting can be adjusted higher or lower, as needed, after
set-up). With source signal present start to set each gain stage in your signal path, starting at the beginning of the
chain. It is best practice to make overall volume changes with the master fader of your mixing console once the
amplifier input trim has been calibrated.
6. When powering down, make sure that the power amplifiers are switched
off first.
QUICK START GUIDE
6
To Next Page
Loading...
Need help?
General
