Need help?Do you have a question about the Wharfedale Pro Pro PM600 and is the answer not in the manual?
General| Channels | 6 |
|---|---|
| Phantom Power | Yes |
| EQ | 3-band |
| Type | Powered Mixer |
| Phono Inputs | No |
| Frequency Response | 20 Hz - 20 kHz |
| Signal-to-Noise Ratio | > 90 dB |
| Microphone Inputs | 2 |
| Line Inputs | 4 |
| Inputs | 2 x XLR, 4 x 1/4" TRS Jack (2 x Stereo) |
| Effects | Built-in effects |
| Outputs | Headphone |
Initial setup steps and precautions before operating the PM system.
Lists key features of the PM500 and PM600 powered mixer sections.
Verifies all components of the PM500 and PM600 systems are present before setup.
Describes the Time, Repeat, and Volume controls for the digital delay effect.
Explains the master output level control for the PM500.
Explains the master output level and three-band EQ for the PM600.
Details on Main Line Out, Speaker Outputs, Fuse, and Heatsink for the PM500.
Details on Main Line Out, Speaker Outputs, Fuse, and Cooling Fan for the PM600.
Specific measurements for the PM600 and PM600 RM units.
Specific measurements for the PM500 and PM500 RM units.
Detailed technical data for the PT-10 and PT-12 loudspeakers.
Technical data for the DM1.0 dynamic microphone, including type and connector.
To Next Page
