AU
First-Last....
shelf positions
1. Control panel
2. Cooling fan* (not visible)
3. Top heating element (can be lowered)
4. Oven light
5. Round heating element (not visible)
6. Fan
7. Bottom heating element (not visible)
8. Door hinge
9. Oven cool door
*N.B.:
The cooling fan switches on only when the
oven has reached a certain temperature.
After the oven switches off, the cooling fan may,
however, continue to run for a certain time to
ensure proper cooling.
ACCESSORIES
• Grid • Catalytic panel
• Pan set kit
OVEN FUNCTIONS TABLE
Function
symbol
Function
Preset
temperature/level
Function description
(see details in the user’s manual)
0 OVEN OFF - -
OVEN LIGHT - To switch on the oven light.
MLTF
(Heat Maintenance)
35C
To keep a constant temperature, either
35° C or 60° C.
STATIC 200C To cook food at one shelf level. Preheating.
PASTRY
(Static+Fan)
175C
To cook on two shelf levels, at the same
temperature.
FAN 160C
To cook on more than one shelf level, at
the same temperature.
GRILL 3 To grill small pieces of meat, toast, etc....
TURBOGRILL
(Grill+Fan)
3 To grill large pieces of meat.
PROGRAMME P1 To bake pizza, bread, focaccia.
First
Last
PRODUCT DESCRIPTION SHEET
Push-Push knobs
• To use this type of knob, press it in the middle.
• Turn the knob to the desired position.
• Once cooking is over, turn the knob back to the position marked by
“0”
and press it again
to restore it to its initial setting.
PRE-HEATING YOUR OVEN
Your Whirlpool oven has a special pre-heating programme to ensure a speedy heat up time.
To pre-heat your oven:
1. Select the
P1
feature on the functions selector knob.
2. Set the required temperature on the temperature selector knob.
3. The temperature is indicated by the lights at the top of the control panel.
4. When the lights are fully lit, the pre-set temperature has been achieved.
5. As a guide, the temperature you select will normally be achieved within 12 minutes.
6. Now select the function and set the time you require, then continue the cooking process.
FOR A DESCRIPTION ON HOW TO USE THE OVEN, PLEASE REFER TO THE
PROGRAMMER DESCRIPTION SHEET.
STARTING THE OVEN
When the oven is connected to the power supply for the first time, or re-connected after a
power failure,
the display shows “”.
To start the oven:
• turn
knob 1
to
“0”
.
• press
button 2
.
The display shows “--:--”.
5019 100 54562
1. Selector knob: to choose the oven functions.
2. Button to select and confirm the different operations (operate by single presses only).
3. Knob to set: time of day, cooking time, the time at which cooking should terminate, the
temperatures and the power levels (Function
P
).
6AKZ 148
1
2
3
To Next Page
Need help?
General