GENERAL INFORMATION
1-6
n
Multi-Door Freestanding Refrigerator
To remove Easy Slide bin:
1. Remove all three crisper drawers.
2. Hold the upper sliding lid near the trim and li up to remove.
Remove lower lid.
3. Grasp the front of the bin with both hands and li up on the
front to remove.
To replace Easy Slide bin:
1. Slightly lt the rear of the bin upward.
2. Align the center rib and tabs on the Easy Slide bin with the ribs
and slots in the cabinet.
3. Lower the bin into place.
A box to store herbs and the water to keep them fresh is
located within the Easy Slide bin. For your convenience, you can
reposion the herb box anywhere along the length of the bin.
1. Slide open one of the bin doors to access the herb box.
2. Remove the herb box from the bin using two hands. One hand
should hold the box while the other hand holds the lid.
3. Grasp the handle between your ngers and li up to remove
the lid.
NOTE: The boom of the herb box is angled so that the roots
of the herbs can be submerged in water while the leaves
remain dry.
The shelves in your refrigerator are adjustable to meet your
individual storage needs.
Storing similar food items together in your refrigerator and
adjusng the shelves to t dierent heights of items will make
nding the exact item you want easier. It will also reduce the
amount of me the refrigerator door is open and save energy.
1. Remove the shelf/frame by lng it up at the front and liing
it out of the shelf supports.
2. Replace the shelf/frame by guiding the rear shelf hooks into
the shelf supports. Tilt the front of the shelf up unl rear shelf
hooks drop into the shelf supports.
3. Lower the front of the shelf and make sure that the shelf is in
posion.
■ The hooks on the rear of the shelf must be fully engaged in
the shelf supports to maintain proper electrical ow.
■ No more than two shelves with under-shelf lighng may be
used in the refrigerator at one me.
1. To retract the front-secon of the shelf, slightly li up on the
front edge and push the adjustable poron of the shelf back
toward the rear of the refrigerator.
2. Extend the front of the shelf by pulling the retracted poron
of the shelf outward unl it is fully extended.
1. Grasp the handle at the boom of the drawer and slide the
drawer straight out to the stop. Li the drawer o the boom
guide.
2. Replace the drawer by placing it on the boom drawer guide
and pushing it past the drawer stop into posion.
1. Remove crisper drawers.
2. Holding the glass insert rmly with one hand, press up in
center of glass insert unl it rises above the plasc frame.
Gently slide the glass insert forward to remove.
3. Li the cover frame up and remove it.
1. Fit back of cover frame into supports on side walls of the
refrigerator and lower the front of the cover frame into place.
2. Slide rear of glass insert into cover frame and lower front into
place.
3. Replace crisper drawers.
The bins on your refrigerator door are adjustable to meet your
individual storage needs.
NOTE: The smallest door bin must be installed in the lowest
posion on the refrigerator door.
Important information to know about glass shelves
and covers:
Do not clean glass shelves or covers with warm water when
they are cold. Shelves and covers may break if exposed to
sudden temperature changes or impact, such as bumping.
Tempered glass is designed to shatter into many small,
pebble-size pieces. This is normal. Glass shelves and covers
are heavy. Use both hands when removing them to avoid
dropping.
To Next Page
Loading...
