2
Quick GuideEN
DELAY - The start time of the program may be delayed for a period of
time between 1 and 12 hours.
The DELAY function cannot be set once a wash cycle has been started.
POWER CLEAN® - Thanks to the additional power jets this option pro-
vides a more intensive and powerful wash in the lower rack, in the spe-
cic area. This option is recommended for washing pots and casseroles.
TABLET (Tab)- If you use powder or liquid detergent, this option
should be o.
OPTIONS AND FUNCTIONS
OPTIONS can be selected directly by pressing the corresponding button (see CONTROL PANEL). If an option is not compatible with the selected
program (see PROGRAMS TABLE), the corresponding LED ashes rapidly 3 times and beeps will sound. The option will not be enabled.
MULTIZONE - If there are not many dishes to be washed, a half load-
ing may be used in order to save water, electricity and detergent.
Bydefault the appliance washes dishes in all racks.
Please scan the QR code on your product in order to have more detailed information.
LOADING THE RACKS
CAPACITY: 14 standard place-settings
More information in the Daily Reference Guide on website.
CLEANING AND MAINTENANCE
CLEANING THE FILTER ASSEMBLY CLEANING THE SPRAY ARMS
A
A
B
C
In case you nd foreign objects (such as broken glass, porcelain, bones, fruit seeds etc.)
please remove them carefully.
NEVER REMOVE the wash-cycle pump protection (black detail) (Fig 4).
To remove the upper spray arm,
turn the plastic locking ring in a
clockwise direction.
The lower spray arm may
be removed by pulling it
upwards.
TURBO - This option can be used to reduce the duration of the main
programs while maintaining the same washing and drying
performance levels.
CUTLERY RACK
(loading example for the cutlery rack)
The third rack was designed to ho-
use the cutlery. Arrange the cutlery
as shown in the gure.
FOLDABLE
FLAPS WITH
ADJUSTABLE
POSITION
POWER CLEAN®
Power Clean® uses the special water jets in the rear of cavity to wash more intensively the high dirty items. The lower rack has a
Space Zone, a special pull-out support in the rear of the rack that can be used to support frying pans or baking pans in upright
position, thus taking up less space.
Placing the pots/casseroles faced to the Power Clean® component please activate the POWER CLEAN® on the panel.
NaturalDry is a convection drying system which automatically opens the
door during/after drying phase to ensure exceptional drying performance
every day. Door opens at the temperature that is safe to your kitchen furni-
ture, thus door will not be opened when the option of TURBO is on.
ECO program data is measured under laboratory conditions according to European Standard EN 60436:2020.
Note for Test Laboratories: For information on comparative EN testing conditions, please send an email to the following address: dw_test_support@whirlpool.com
Pre-treatment of the dishes is not needed before any of the programs.
*) Not all options can be used simultaneously.
**) Values given for programs other than the program Eco are indicative only. The actual time may vary depending on many factors such as temperature and
pressure of the incoming water, room temperature, amount of detergent, quantity and type of load, load balancing, additional selected options and sensor cali-
bration. The sensor calibration can increase program duration up to 20 min.
UPPER RACK
Load delicate
and light dish-
es: glasses, cups,
saucers, low salad
bowls.
The upper rack
has tip-up sup-
ports which can
be used in a verti-
cal position when
arranging tea/
dessert saucers
or in a lower posi-
tion to load bowls and food containers.
(loading example for the
upper rack)
LOWER RACK
For pots, lids,
plates, salad
bowls, cutlery etc.
Large plates and
lids should ideally
be placed at the
sides to avoid in-
terferences with
the spray arm.
The lower rack has
tip-up supports
which can be used
in a vertical posi-
tion when arranging plates or in a horizontal po-
sition (lower) to load pans and salad bowls easily.
(loading example for the
lower rack)
To Next Page
Loading...
