Why won't my Whirlpool WIE 2B16 Dishwasher start?
Your Whirlpool Dishwasher might not start due to several reasons: it may not be properly plugged in, so ensure the plug is fully inserted into the socket. There might be a power outage; the dishwasher will automatically restart when power is restored. The door might not be closed correctly; push the door firmly until you hear a click.
What to do if my Whirlpool WIE 2B16 won’t drain?
If your Whirlpool Dishwasher isn't draining, it could be because the wash cycle hasn't finished yet, so wait until it completes. Alternatively, the drain hose might be bent; check and straighten it if necessary. The sink drain pipe could be blocked; try cleaning it. The filter might be clogged with food residues; in this case, clean the filter.
Why are the dishes not clean in my Whirlpool WIE 2B16 Dishwasher?
If your dishes aren't getting clean in your Whirlpool Dishwasher, consider these possibilities: the dishes may not be arranged properly, preventing proper cleaning; make sure to arrange the crockery correctly. The spray arms might be blocked by dishes, preventing them from rotating freely; arrange the crockery correctly. The selected wash cycle may be too gentle; select a more appropriate wash cycle. Too much foam might be present due to incorrect detergent usage; use the correct amount and type of detergent. The rinse aid compartment cap may not be closed properly; ensure it is closed tightly. The filter might be dirty or clogged; clean the filter assembly. Finally, the salt reservoir might be empty; fill it with salt.
How to reduce excessive noise from Whirlpool Dishwasher?
Excessive noise from your Whirlpool Dishwasher can be caused by dishes rattling against each other; arrange the crockery correctly. It may also be due to an excessive amount of foam; ensure the detergent is measured correctly and is suitable for dishwashers. You can reset the dishwasher by pressing the DRAIN button and running a new program without detergent.
What to do if Whirlpool Dishwasher does not respond to commands?
If your Whirlpool Dishwasher isn't responding to commands, try switching off the appliance by pressing the ON/OFF button. After about a minute, switch it back on and reset the program.
General| Appliance placement | Freestanding |
|---|---|
| Product size | Full size (60 cm) |
| Control panel colour | White |
| Noise level | 46 dB |
| Number of washing programs | 5 |
| Drying system | Static |
| Cycle time | 190 min |
| Delayed start timer | Yes |
| Connected load | 1900 W |
| Current | 10 A |
| Half Load | No |
| Washing programs | Eco, Intensive |
| Water consumption per cycle | 11 liters |
| Number of place settings | 13 place settings |
To Next Page