Why my Whirlpool Dishwasher does not run?
If your Whirlpool Dishwasher isn't running, first, ensure the power plug is correctly connected to the power source and that the dishwasher is powered on with the door well closed. Also, check the water supply equipment to be sure the faucet is turned on, as low water pressure can prevent the dishwasher from starting.
How to remove bubbles from Whirlpool Dishwasher?
To prevent bubbles in your Whirlpool Dishwasher, use detergent powder or 3-in-1 dishwasher tablets specifically designed for dishwashers. If bubbles do appear, open the dishwasher to let them evaporate, then close the door and press the "Start/Pause" button for 3 seconds to discharge the water. Repeat this until the bubbles are gone.
What causes E2 error in Whirlpool WCTD104HK?
E2 error in Whirlpool Dishwasher may be caused by components damages (e.g. inlet valve damage, flow meter damage), no water flow in (water tap and inlet hose is not connected correctly to the inlet valve), or line break (flow meter is off).
What does E3 error mean on a Whirlpool WCTD104HK Dishwasher?
E3 error in Whirlpool Dishwasher may be caused by residues stuck at drain inlet, drain hose being squeezed or lifted, or drain pump damage.
What does E6 error indicate on Whirlpool Dishwasher?
E6 error in Whirlpool Dishwasher may be caused by water leakage or the washing pump stopping operation and the micro switch being off.
What does E7 error mean on Whirlpool WCTD104HK Dishwasher?
E7 error in Whirlpool Dishwasher may be caused by the heating panel not heating or the temperature controller on the heating panel being off (one temperature controller should be restored manually and the other automatically).
General| Number of Wash Cycles | 6 |
|---|---|
| Number of Options | 4 |
| Dishwasher Interior Material | Stainless Steel |
| Number of Programs | 6 |
| Control Type | Electronic |
| Delay Start | Yes |
To Next Page