Why is my WhisperKool XLT XLT 1600 not running or clicking?
If your WhisperKool Wine Cooler isn’t running or is making intermittent clicking noises, the issue might stem from a problem with your local electrical circuit. For troubleshooting, refer to the 'Power Requirements' section on page 22.
How to troubleshoot a WhisperKool XLT XLT 1600 Wine Cooler that is not cooling?
If your WhisperKool Wine Cooler does not cool the room adequately, it might be due to an inadequate door seal (refer to the 'Door Seal' section on pg. 20). It could also be caused by an improperly mounted unit (see 'Unit Mounting' section on pg. 21), or inadequate ventilation (check 'Airflow' and 'Ventilation' sections on pgs. 19 and page 11 in the 'Installation' section).
What to do if my WhisperKool XLT XLT 1600 Wine Cooler is icing up?
If your WhisperKool Wine Cooler is icing up, it could be due to poor air flow. Check the 'Thermostat' section on page 21 for guidance. Alternatively, the unit might be low on refrigerant (refer to the 'Icing Up' section on page 22), or the probe might not be correctly positioned in the bottle (see the 'Liquid Measuring Thermostat' section on page 1).
Why is my WhisperKool Wine Cooler leaking water from the rear?
If water is leaking from the rear of your WhisperKool Wine Cooler, it could be because the Condensate Evaporator isn't properly set for your local climate. See the 'Condensation' section on page 22 under 'Water Leaking, Rear' for instructions. Another potential cause is that the drain line isn't attached; consult the 'Drain line' section on page 13 to resolve this.
General| Brand | WhisperKool |
|---|---|
| Model | XLT SERIES XLT 1600 |
| Category | Wine Cooler |
| Language | English |
Guidance on checking the unit for damage upon arrival and handling potential issues.
Critical importance of maintaining clear airflow around the unit for optimal performance and cooling.
Recommendations for high mounting of the unit to ensure effective circulation of cool air.
Emphasizes the need for a well-sealed cellar door to prevent cool air escape and unit inefficiency.
Requirements for a dedicated 110-volt 20-amp circuit for the unit's operation.
Procedure for testing the unit's cooling function before final installation.
Addresses airflow issues that can impact unit performance and cooling efficiency.
Discusses ventilation problems and solutions for proper heat dissipation.
Details the importance of a good door seal for preventing cool air loss.
Explains the impact of unit mounting position on cooling performance.
Provides steps to test the thermostat for cooling issues.
Checklist items related to insufficient or complete lack of cooling.
Checklist items pertaining to water leaks from the unit.
Checklist items concerning the unit developing ice buildup.
Checklist items for problems like short cycling, clicking, or tripping breakers.
Contact information and required details for seeking technical support.
To Next Page
