What to do if my WhisperKool Wine Cooler is not cooling?
If your WhisperKool Wine Cooler isn't cooling, the thermostat might be set too warm. Try lowering the set temperature. Also, the thermostat may not be operating correctly and require testing with a bypass plug. If neither of these solutions work, the unit might be low on refrigerant or Freon, potentially needing professional service. Contact Customer Service in this case.
Why does my WhisperKool Wine Cooler run constantly?
If your WhisperKool Wine Cooler runs constantly, the thermostat setting might be too cool; try raising the set temperature. If you recently loaded the cabinet with wine, allow several weeks for it to reach the optimal storage temperature. Ensure the ambient room temperature is suitable, as these units are designed to cool 30°F below room temperature. Adequate ventilation is also crucial, so make sure there's proper space above, behind, and on the sides of the unit, and avoid placing anything on top. Finally, check that the door gasket is sealing properly.
Why my WhisperKool Wine Cooler will not start?
If your WhisperKool Wine Cooler will not start, ensure the wine probe line is properly placed in a bottle of water, not stretched, and that all connections are secure. Also, check if the circuit breaker has tripped; if so, reset it and verify the unit is connected to a dedicated 20-amp outlet that is not a ground fault interrupter. Lastly, make sure the temperature setting is correct by adjusting it as needed.
Why is my WhisperKool Wine Cooler icing up?
If your WhisperKool Wine Cooler is icing up, it could be due to the unit running constantly. Refer to the section addressing units running constantly for solutions. Another possible cause is low refrigerant or Freon, which may require professional service. Contact Customer Service in this case.
Why is my WhisperKool Wine Cooler making a clicking noise during start-up?
A clicking noise during start-up in your WhisperKool Wine Cooler can be caused by outlet power issues. Ensure that the unit is connected to a dedicated 20-amp outlet and not a Ground Fault Interrupter (GFI).
Instructions for installing the thermostat probe into a wine bottle for accurate temperature measurement.
Describes the sequence of events and symbols displayed when the unit is first powered on.
Explains the operation of the compressor and fans after the set point is reached.
Explains how to access and adjust various settings via the CPSM, including humidity and pre-chill.
Details the two-year limited warranty for labor, parts, and freight, and the five-year compressor warranty.
Outlines mandatory installation procedures, manual usage, and the user's responsibility for costs.
General| Brand | WhisperKool |
|---|---|
| Model | 2500 |
| Category | Wine Cooler |
| Language | English |
To Next Page
