Wholesale Interiors ALESHA User Manual

STEP 1 STEP 2
STEP 3
STEP 4
ITEM : ALESHA - FB/QB
ASSEMBLY INSTRUCTION
QTY
1PC
PART LIST
NO
HEADBOARD
CUSHION
RIGHT HEADBOARD LEG
WITH 'R' LABEL
WINGS
FOOTBOARD
CUSHION
FOOTBOARD
LEGS
SIDE RAIL
SIDE RAIL
SIDE RAIL
SUPPORT LEG
QTY
HARDWARE LIST
NO
SUPPORT LEGS
WITH ADJUSTABLE FEET
SLATS
JCBC SCREW
M6 X 70
JCBC SCREW
M6 X 35
JCBC SCREW
M6 X 25
JCBB SCREW
M8 X 20
L - KEY
M5 X 65mm
SCREW
M4 X 32mm
FLAT WASHER
SPRING WASHER
WOOD DOWEL
LEFT HEADBOARD LEG
WITH 'L' LABEL
L - KEY
M4 X 65mm
1PC
1PC
1PC
1PC
1PC
2PCS
2PCS
2PCS
2PCS
2PCS
2PCS
2PCS
4PCS
4PCS
8PCS
8PCS
8PCS
20PCS
20PCS
16PCS
1
2
3
4
5
6
7
8
9
10
11
Make sure the cleat is
on outside edge
Do not fully tighten screws
until assembly is complete
and the bed is level
Do not fully tighten screws
until assembly is complete
and the bed is level
Begin assembly by attaching each headboard leg (2) & (3) to the
bottom of headboard cushion (1) by aligning the hole and securing with
3 Allen bolts (C), 3 spring washer (F), 3 flat washer (G) per leg using
L-key (J).
Attach the side rail support leg (9) to join of the side rail (7) &
side rail (8) by securing with 4 Allen bolts (B) , 4 spring washer (F) ,
4 flat washer (G) per support using L-key (J).
Attaching each wing (4) to each side of headboard cushion (1) by
aligning the hole and securing with 3 Allen bolts (C) , 3 spring
washer (F) , 3 flat washer (G) per side using L-key (J).
Attach each footboard legs (6) to the bottom of the footboard cushion
(5) by inserting a dowel (E) & securing with 1 Allen bolt (D) per leg
using L-key (J).

Wholesale Interiors ALESHA Specifications

General

Brand	Wholesale Interiors
Model	ALESHA
Category	Indoor Furnishing
Language	English

Summary

Bed Assembly Steps

Attach Headboard Legs

Secure headboard legs to the headboard cushion using Allen bolts, spring washers, and flat washers.

Attach Headboard Wings

Connect wings to the sides of the headboard cushion using Allen bolts, spring washers, and flat washers.

Attach Footboard Legs

Fasten footboard legs to the footboard cushion using dowels and Allen bolts.

Attach Side Rail Support Legs

Connect side rail support legs to the side rails using Allen bolts, spring washers, and flat washers.

Attach Side Rails

Connect side rails to the headboard and footboard legs. Do not tighten bolts at this stage.

Install Slats and Support Legs

Attach support legs to slats and slats to side rails. Tighten all previously loose bolts.

Final Assembly Check

Indicates the assembly is completed and advises on final tightening after acclimatization.