Wholesale Interiors CANDACE User Manual

CANDACE - KB
LIST
L
R
(LEFT)
(RIGHT)
STEP 1
Begin assembly by attaching each headboard leg (2) & (3) to the bottom of the headboard cushion
(1) by aligning the hole and securing with 3 Allen Bolts (C) , 3 spring washer (F) , 3 flat washer
(G) per leg using L-key (J). (DO NOT FULLY TIGHTEN BOLTS FOR THIS STEP)
STEP 2
Attach each footboard legs (5) to the bottom of the footboard cushion (4) by inserting a dowel (E)
& securing with 1 Allen Bolt (D) per leg using L-key (J).
NOTE : AFTER A FEW DAYS , IT WILL HAVE ACCLIMATIZED TO THE ENVIRONMENT.
PLEASE TIGHTEN ALL HARDWARE. CHECK TIGHTNESS OD ALL SCREWS EVERY 6-8 WEEKS.
Make sure the cleat is
on outside edge
Do not fully tighten screws
until assembly is complete
and the bed is level

Wholesale Interiors CANDACE Specifications

General

Brand	Wholesale Interiors
Model	CANDACE
Category	Indoor Furnishing
Language	English

Summary

Assembly Instructions

Step 1: Headboard Leg Attachment

Attach headboard legs to the headboard cushion using Allen bolts, spring washers, and flat washers.

Step 2: Footboard Leg Attachment

Attach footboard legs to the footboard cushion using dowels and Allen bolts.

Step 3: Side Rail Support Leg Attachment

Attach side rail support legs to the side rails with Allen bolts, spring washers, and flat washers.

Step 4: Side Rail to Headboard/Footboard Attachment

Attach side rails to the headboard and footboard legs using Allen bolts.

Step 5: Slat and Support Leg Installation

Attach support legs to slats and slats to side rails using bolts and screws.

Step 6: Assembly Completion

Indicates the final stage of the assembly process.