Wholesale Interiors DARCY User Manual

LIST
(LEFT)
(RIGHT)
STEP 1
Begin assembly by attaching each headboard leg (2) & (3) to the bottom of the headboard cushion
(1) by aligning the hole and securing with 3 Allen Bolts (C) , 3 spring washer (F) , 3 flat washer
(G) per leg by using L-key(J). (DO NOT FULLY TIGHTEN BOLTS FOR THIS STEP)
STEP 2
Attach each footboard legs (5) to the bottom of the footboard cushion (4) by inserting a dowel (E)
& securing with 1 Allen Bolt (D) per leg using L-key (J).
NOTE : AFTER A FEW DAYS , IT WILL HAVE ACCLIMATIZED TO THE ENVIRONMENT.
PLEASE TIGHTEN ALL HARDWARE. CHECK TIGHTNESS OD ALL SCREWS EVERY 6-8 WEEKS.
Make sure the cleat is
on outside edge
Do not fully tighten screws
until assembly is complete
and the bed is level
R
L
ITEM : DARCY - KB

Wholesale Interiors DARCY Specifications

General

Brand	Wholesale Interiors
Model	DARCY
Category	Indoor Furnishing
Language	English

Summary

Step 1: Headboard Assembly

Attach Headboard Legs

Secure headboard legs (2 & 3) to headboard cushion (1) using Allen bolts (C), spring washers (F), flat washers (G) and L-key (J). Do not fully tighten.

Step 2: Footboard Assembly

Attach Footboard Legs

Attach footboard legs (5) to footboard cushion (4) using dowel (E) and Allen bolt (D) with L-key (J).

Step 3: Side Rail Support Assembly

Attach Side Rail Support Leg

Connect side rail support leg (8) to side rails (6 & 7) using Allen bolts (B), spring washers (F), flat washers (G) with L-key (J).

Step 4: Connecting Side Rails

Attach Side Rails to Legs

Connect side rails to headboard legs (2 & 3) and footboard (4) using Allen bolts (A) with L-key (I). Do not fully tighten.

Step 5: Slat and Support Leg Installation

Attach Support Legs to Slats

Secure support legs (10) to slats (9) using Allen bolt (C) and L-key (J).

Attach Slats to Side Rails

Fasten slats (9) to side rails using screws (H) with a Philips head screwdriver.

Step 6: Final Assembly Check

Complete Assembly

Finalize assembly by tightening all previously un-tightened bolts and screws to ensure the bed is level.