Guide the tip of the anchor through
the small hole on the side of the tub-
ing as illustrated to form a heart-sha-
ped loop.
When the loop is the correct size, turn
the ear-set around and cut off any ex-
cess with scissors or a similar imple-
ment.
The anchor loop is the correct size when it supports the position of the hear-
ing aid in the ear, and when the ear-set sits securely in and on the ear.
NOTE
Make sure that the end of the anchor loop is flush with the small hole and that
there are no sharp edges, as this may cause irritation in your ear. Use the tip of
your finger to check for sharp edges.
NOTE
The integrated anchor is NOT used with a custom ear-set solution and should be
completely cut off.
37
To Next Page
Loading...
