14
Fitting the hearing aids
Hearing aids which have never previously been fitted must be assigned to
the correct side (i.e. right and left) in Compass.
Detect hearing aids as follows:
1. To identify hearing aids, make sure they are placed inside the neck loop
close to the USB Link unit. Use the Play buttons under Identify HA.
When you select a play button, the relevant hearing aid plays a sound
for 6 seconds, and in some models a light-emitting diode lights up.
1
2. While this is happening, remove the hearing aid from the Widex USB
Link and listen to it.
3. In Compass, select whether the hearing aid is for the left or right ear.
4. Repeat the procedure if you are fitting two hearing aids.
5. Click Next to connect the hearing aids.
To Next Page
Loading...
