5.2 Thermal contact medium
When using thermowells, they must be lled with a thermal contact
medium in order to reduce the heat transfer resistance between the
outer wall of the probe and the inner wall of the thermowell. The working
temperature of the thermal compound is -40 ... +200 °C.
WARNING!
Physical injuries and damage to equipment due to oil
spraying out
When pouring a thermal contact medium into a hot
thermowell, there is a danger of physical injuries and damage
to equipment due to oil spraying out.
▶
Do not ll hot thermowells
6. Faults
Personnel: Skilled personnel or service personnel
Tools: Suitable spanner
CAUTION!
Physical injuries and damage to property and the
environment
If faults cannot be eliminated by means of the listed
measures, the instrument must be taken out of operation
immediately.
▶
Ensure that pressure or signal is no longer present and
protect against accidental commissioning.
▶
Contact the manufacturer.
▶
If a return is needed, please follow the instructions given
in chapter 8.2 “Return”.
5. Commissioning, operation / 6. Faults
To Next Page
Loading...
Need help?
General
