WIKA S-10 User Manual

EN
14 WIKA operating instructions pressure transmitter, model S-10
1604457.16 09/2017 EN/DE/FR/ES
Faults Causes Measures
No output signal Cable break Check the continuity
Deviating zero point signal Overload safety exceeded Observe the permissible overload safety
Deviating zero point signal Too high/low working temperature Observe the permissible temperatures
Constant output signal upon change in
pressure
Mechanical overload caused by overpres-
sure
Replace instrument; if it fails repeatedly,
contact the manufacturer
Signal span varies EMC interference sources in the environ-
ment; for example, frequency converter
Shield instrument; cable shield; remove
source of interference
Signal span varies/inaccurate Too high/low working temperature Observe the permissible temperatures
Signal span drops/too small Mechanical overload caused by overpres-
sure
Replace instrument; if it fails repeatedly,
contact the manufacturer
If complaint is unjustied, we will charge you the complaint processing fees.
7. Faults

WIKA S-10 Specifications

General

Brand	WIKA
Model	S-10
Category	Transmitter
Language	English