4
INTRODUCTION
1. Carefully remove the crating and packing
materials. CAUTION! Be careful when cutting
steel/nylon banding material as items may
become loose and fall causing personal harm
or injury.
2. Inspect the lift for any signs of concealed
shipment damage or shortages. Remember
to report any shipping damage to the carrier
and make a notation on the delivery receipt.
3. Check the voltage, phase and proper
amperage requirements for the motor shown
on the motor plate. Wiring should be
performed by a certified electrician only.
IMPORTANT SAFETY INSTRUCTIONS
Failure to read these instructions completely may result in injury to user, and
other people within the area of the lift, or vehicles. We are not responsible for
any injury or damage as a result of not carefully reading and following these
instructions.
Operating controls are designed to close when released. Do not block open or
override them.
NEVER overload your lift. Manufacturer’s rated capacity is shown on name plate
affixed to the lift. ALWAYS be clear of the gross weight of vehicle.
NEVER use the lift to raise one end or one side of vehicle.
NEVER raise vehicle with anyone inside it. No one should be in the lift area
during operation.
ALWAYS keep lift area free of obstructions, grease, oil, trash and other debris.
Before lowering lift, be sure tool trays, stands, etc. are removed from under
vehicle. Release locking devices before attempting to lower lift.
Adequate ventilation should be provided when working with internal combustion
engines.
Use only manufacturer’s recommended attachments.
KEEP HANDS AND FEET CLEAR from any moving parts. Keep feet clear of lift
when lowering. Avoid pinch points.
GUARD AGAINST ELECTRIC SHOCK. This lift must have ground connection
during use to protect the operator from electric shock.
DANGER! The power unit used on this lift contains high voltage.
Turn off power before performing any electrical repairs.
WARNING! RISK OF EXPLOSION. This equipment has internal arcing or sparking
parts which should not be exposed to flammable vapors. This machine should
not be located in a recessed area or below floor level.
To Next Page
Loading...