Four Post Parking Lift WF9000&WF9000XLT
The power source or power
equipment is malfunctioning.
Check up the power fuse, the
contact in the junction box of
motor, micro switch, and the
condition of up button, change the
damaged part.
Generator roars
and does not
work.
a. The top of vane wheel is
deformed.
b. Capacitor is damaged.
c. The voltage is too low.
The equipment is used overload.
a. straightening
b. replace for new parts
c. check up by electric technicians
When the lift is
rising,it creeps.
Air has entered the hydraulic system,
and the oil box lacks oil.
Rise repeatedly to remove the air,
and add oil to oil box.
Noise is too loud
when the lift is
working.
The sliding and rotational part lacks
lubrication and or change the pin roll.
Add lubrication, change the pin
roll.
a. There is something wrong with the
power unit.
b. the button on the power unit is
damaged.
c. Leakage of oil pipeline
a. Maintain or change for new
parts.
b. Maintain or change for new
parts.
c. Clean, tighten and change for
new parts.
When lift is rising
the speed is slow
and heavy.
a. There is not enough hydraulic oil.
b. Leakage of oil pipeline
c. Oil filter is stopped up.
a. Add hydraulic oil
b. Maintenance, tighten and
change for new parts.
c. Disassemble and clean.
a. The security block is not open.
b. Magnets are damaged heavily.
a. Rise first then drop, or
maintain.
b. Change for new parts.
Motor “clicking” on start up
UNDER POWERED. STOP
immediately and correct.
- Make sure lift is plugged
into a 20 amp outlet
- If using an extension cord
it must be a 12gauge at
minimum
- If still clicking after above
two, remove GFCI from
the electrical run
To Next Page
Loading...