Wilfa CHILL 12 CONNECTED - Timer Setting Functionality; Overload Protection Feature; Water Drainage Management; Manual Drainage Procedure

16
INSTRUCTION MANUAL · AIR CONDITION
EN
TIMER SETTING (1HOUR-24HOURS)
The timer has two ways of operation:
To turn off
(When power
on)
è
Press the Timer key
to turn on the timer
function.
è
Press Up /Down
repeatedly to set the
delay OFF time.
To turn on
(When power
off)
è
Press the Timer key
to turn on the timer
function.
è
Press Up /Down
repeatedly to set the
delay ON time.
Cancel timer
è
Press Up /Down repeatedly until the LED shows ‘00’.
Note: by pressing POWER you will also cancel the
timer
OVERLOAD PROTECTION
In the event of a power loss, to protect the compressor there is a 3-minute delay
until the compressor restarting.
DRAINAGE
MANUAL DRAINAGE
1. When the machine stops after the water is full, please unplug the power plug.
Notes: Please move the machine carefully, so as not to spill the water in the water
pan at the bottom of the body.
2. Place the water container below the side water outlet behind the body.
3. Unplug the water plug, the water will automatically ow into the water container.
Notes:
1. Keep the water plug properly.
2. During drainage, the body can be tilted slightly backwards.
3. If the water container cannot hold all the water, before the water container is full,
stuff the water outlet with the water plug as soon as possible to prevent water from
owing to the oor or the carpet.
4. When the water is discharged, stuff the water plug.
Notes: Restart the machine after the water plug and drainage cover are installed,
otherwise condensate water of the machine will ow to the oor or the carpet.
SELF- EVAPORATING SYSTEM
The self-evaporating system uses the collected water to cool the condenser coils
for better, more efcient performance. There is no need to empty the drainage
tank in cooling mode, except in high humidity conditions. In drying mode, the
drainage tank needs to be emptied. The condensed water evaporates at the