23
EN
KITCHEN MACHINE · KM2GY-T70, KM2BS-T70
Problem Possible Cause Action
Whisk hits bottom
of bowl
Not enough content
in bowl
(The whisk balloons are
designed to automatically
adjust their height based
on content. This means that
with a very small amount of
content the whisks might
touch the bottom of the
bowl)
Add more content
Machine will
not start
Power switch next to the
power inlet is in OFF
position (O)
Set power switch to the ON
position (I)
Power cable not
properly in place
Ensure the plug is fully
connected
Head is not properly
closed
Close the head until it properly
locks in place
Motor is overheated Probaker cuts power when the
motor temperature becomes
too high. Unplug the device
and let it cool for at least 30
minutes
Speed indicator
ring is blinking on
power up
Speed not set to 0
when machine starts
Set speed knob to 0
The flexi-beater
silicone scraper
loosens
Debris or grease in the
mounting point
Clean silicone ring and the
flexi-beater thoroughly with
soapy water or in dishwasher
The flexi-beater is not
the correct tool for
heavier doughs like
yeasted dough and
shortcrust pastry
Refer to “tool section”. If in
doubt use the spiral hook
To Next Page
Loading...