Williams 5009622A - Basic Materials Needed; Basic Tools Needed; Optional Accessories

6 MONTEREY TOP VENT GAS WALL HEATER
Basic Materials Needed
Pipe and fittings to make gas connections to the furnace.
Vertical venting materials. See page 15, Figure 8.
Pipe joint compound resistant to propane.
Electrical wiring supplies as needed. Minimum wire size is
#14 gauge copper.
Basic Tools Needed
Hand drill or properly grounded electric drill
Expansion bit 1/2” to 1-5/8” or 1/2” and 1-1/2” blade bits
1/8” and 3/16” drill bit (metal)
6 ft. folding rule or tape measure
Screwdriver (medium blade)
Screwdriver (Phillips and Flat Head)
Pliers (wire cutting)
Hammer
Stud Locater or small finishing nails
Tin Snips
8" adjustable wrench
12" adjustable wrench
7/8" wrench
3/4" wrench
1" wrench
Gloves and safety glasses
Helpful Installation Information
The following booklets will help you in making the installation:
ANSI/NFPA 70, or current edition “National Electrical Code”.
In Canada: CSA C22.1 Canadian Electrical Code.
American National Standard Z223.1 or current edition of the
“National Fuel Gas Code.”
Obtain from the American National Standard Institute, Inc.,
1430 Broadway, New York, NY 10018. In Canada, CAN/CGA B149.
Optional Accessories
Blower Accessories 2901, 2907 - May be used on all models
and mounts on top of a furnace. This blower increases
circulation of warm air through the heated space. A 115V
outlet adjacent to the furnace is required.
Trim Strip Kit 4701 - Provides a finished edge for sides of the
wall furnace.
Free Standing Accessory 4901 - May be used with
single&sided models. This accessory allows the furnace to be
mounted on the surface of a wall.
Vent Adapter Kit 9902, 9910 - Optional vent adapter,
typically used when the furnace is vented into a properly lined
chimney.
Rear Outlet Registers 6901, 6919, 6920 - May be used with
single&sided models when recessed into a standard 2x4
inch interior stud partition. This accessory directs some of
the heated air into the room opposite the one in which the
furnace is installed.
Oval B/W Vent Kit 9929 - This U.L. listed B/W vent kit
contains four feet of oval, double&walled vent pipe, plate
spacers and base or hold&3own plate that starts the venting
from the top of furnace. See Vent Installation on page 15 for
additional items you will need.
Plaster Ground Kit 6905 - Used for 6901 or 6919 Rear
Outlet Registers.
Gas Conversion Kits - See page 17.
Thermostat - See page 20.
INTRODUCTION