25
24
instructional videos willowpump.com | customer care 1-888-WILLOW-3 Willow Breast Pump Instructions for Use
7. INSTRUCTIONS FOR USE
7A. GET READY
1. BOIL FLANGE & FLEXTUBE
™
FOR FIRST USE ONLY
b. Boil Flange and Flextube
™
for 10 minutes and place on a clean surface to air dry.
2. WAKE UP WILLOW
Pump comes partially charged, but needs to wake up.
a. Plug Charger into outlet, then into Pump.
b. Wait until Pump lights up.
c. Unplug Charger from Pump.
fig 1a Hold Pump
upright, then
open by squeezing
the two buttons on
the top-sides
of Flange.
fig 1b Pull top open
first, then unhook
Tab and Slot.
a. Separate Flange from Pump
3. ASSEMBLY
BEFORE USING PUMP Examine Pump and parts for any damage, cracks, chips or wear.
a. Connect Flextube
™
to Flange
fig 3a Push Flextube
™
Tip all the way down
onto Flange Spout.
fig 3b Slide Flextube
™
Collar into top of
Flange. Listen for Collar
to ‘click’ into place.
click!
Make sure the
edges are flush.
To Next Page
Loading...
