31
Installation
• The cooker may be located in a kitchen, a kitchen/diner or bed-sitting room in accordance with the latest
editions of BS6172, BS5440-2 and BS6891, but not in a room containing a bath or shower. Please refer to the
local legislation/regulations to ensure location is permitted.
• If the cooker is installed adjacent to furniture which is higher than the gas hob, a gap of at least 65 mm must
be left between the side of the cooker and the furniture unless non-combustible materials (ceramic tiles, metal
backsplash etc.) are used, then no gap is necessary.
• Prior to installation, ensure that the local distribution conditions (nature of the gas and gas pressure) and the
adjustment of the appliance are compatible. The adjustment conditions for this appliance are stated on the
label (or data plate).
• The furniture walls adjacent to the cooker must be made of heat resistant material (check with your furniture
supplier). The veneered synthetic material and the glue used must be resistant to a temperature of 100°C in
order to avoid ungluing or deformations.
• Flammable materials such as curtains, wood, wallpaper etc. must not be fitted immediately behind the
appliance or within 500 mm of the sides.
• We recommend not to place your appliance next to a refrigerator.
• This cooker must NOT be placed on a pedestal or base.
• It is essential that the cooker is positioned as stated or freestanding ensuring the distances to flammable
materials etc. are still observed.
• Any cooker hoods must be installed according to the requirements of the cooker hood instruction/installation
manual but no less than 650 mm above the cooker.
• Any cupboards placed directly above the cooker must be no less than 750 mm.
Cupboard
420 mm
650 mm
1000 mm
420 mm
750 mm
X
1000 mm
X
900 mm
500 mm
Cupboard Cooker Hood
* All images are for indication only; please refer to your individual unit for actual item.
For all dimensions marked “X”, please
refer to the information below:
X : 65mm for combustible materials
• The cooker must be installed by a competent and Gas Safe Registered Engineer (in the UK) and in
compliance with local safety and building regulation safety standards.
To Next Page
Loading...
