Wilson Electronics weboost DRIVE REACH FLEET - Step 5: Connect Coax Cables To Booster

9
PROFESSIONAL VEHICLE SIGNAL BOOSTER KIT DRIVE REACH FLEET
______
Step 5: Connect Coax
Cables To Booster
Connect the cable from the NMO antenna to the port labeled
“Outside Antenna” on the booster.
Connect the cable from the in-vehicle antenna to the port
labeled “Inside Antenna” on the booster.
from Outside Antenna
from Inside Antenna
NOTE: Bracket can be used to fasten booster in a specific location if desired.
bracket
Drive Reach