DRIVE REACH FLEET PROFESSIONAL VEHICLE SIGNAL BOOSTER KIT
4
apply silicone grease
After hole has been drilled, insert NMO mounting cable
through (connector end first) and remove collar.
Position threads of the cable mount above vehicle surface.
Apply included silicone grease to the o-ring on the collar then
screw the collar to the base mount to seal opening. Ensure the
mount is centered in the hole and tighten with wrench.
screw collar
to base mount
For a professional installation, we recommend routing the cable
under the headliner and down through the side trim panel to
the desired booster location on the floor of the vehicle.
side trim panel
headliner
r
u
n
c
a
b
l
e
f
r
o
m
N
M
O
O
u
t
s
i
d
e
A
n
t
e
n
n
a
t
o
b
o
o
s
t
e
r
______
Step 2: Mount NMO
Outside Antenna
remove
collar
insert through hole
To Next Page
Loading...
Need help?
General
