Wilson Electronics weboost Drive Reach OTR User Manual

STEP 1: Select Mounting
Location & Assemble the
Outside Antenna
STEP 2: Mounting the
Outside Antenna
STEP 5: Connect Power
Supply To Booster
STEP 4: Booster Location
& Connect Cables
STEP 3: Mounting the
Inside Antenna
Find a location to place the Drive Reach
Booster and secure it with provided bracket.
Connect cable from Outside Antenna to
labeled booster port and connect cable from
Inside Antenna to labeled booster port.
Identify a place to mount the In-Vehicle
Antenna, either on the side of the seat
or on the dash and mount. The location
should be at least 18 inches but no
more than 36 inches from where the
cellular device will be used.
Once you have determined the best location
for the Outside Antenna, insert cable through
mast(s) then through Side Exit Adapter.
Screw together as shown.
Refer to Installation Guide for Detailed Instructions.
®
from Inside
Antenna
from Outside
Antenna
Booster
If the vehicle does not have built-in
mounting points, a Three-way Mount
is included that will work on vehicles
with mirror rails. For more info on
using Spring, see Installation Guide.
Connect the power supply cord to the end
of the booster, labeled “ ”, and plug
the power adapter into vehicles 12V DC
power supply. Enjoy your boosted signal!
c
a
b
l
e
c
a
b
l
e
c
a
b
l
e
c
a
b
l
e
c
a
b
l
e
c
a
b
l
e
c
a
b
l
e
c
a
b
l
e
c
a
b
l
e
c
a
b
l
e
c
a
b
l
e
c
a
b
l
e
c
a
b
l
e
c
a
b
l
e
c
a
b
l
e
Dierent Assembly Options
3-Way Mount
shown
Side Exit
Adapter
Mast
t
o
B
o
o
s
t
e
r
Side Exit
Adapter
mast
mast
Drive OTR
Outside Antenna
c
a
b
l
e
f
r
o
m
a
n
t
e
n
n
a
In-Vehicle
Antenna
Velco®

Wilson Electronics weboost Drive Reach OTR Specifications

General

Brand	Wilson Electronics
Model	weboost Drive Reach OTR
Category	Extender
Language	English