Troubleshooting
FIXING BLINKING
OR
RED LIGHT ISSUES
This section
is
only applicable if
the
Booster
is
red
or
blinking red and you are not
experiencing
the
desired signal boost.
1 Unplug
the
Booster's
power
supply.
2 Relocate
the
inside and outside antenna further from each other. The objective is
to
increase
the
separation distance between them, so
that
they
will
not
create this
feedback condition discussed before.
3 Plug
power
supply
back
in.
4 Monitor
the
indicator light on
your
Booster.
If,
after a
few
seconds
of
'power
on', a solid
or
blinking red light appears, repeat steps 1 through
3.
Increase
the
separation distance until
the
condition is corrected and/
or
desired coverage area
is
achieved. Note: Horizontal separation
of
the
two
antennas typically requires a
shorter separation distance than vertical separation.
If you are having
any
difficulties while testing
or
installing
your
Booster, contact our
weBoost Customer Support team
for
assistance (866.294.1660).
II
To Next Page
Loading...
Need help?
General
