BEFORE YOU START
9
UNPACKING THE MITER SAW
WARNING:
To avoid injury:
• Do not plug the power cord into the power source during
unpacking or assembly.
• If any part is missing or damaged, do not connect the miter saw
to the power source until the missing or damaged part is
replaced and assembly is complete.
• Avoid fire and toxic reaction. Never use gasoline, naphtha,
acetone, lacquer, thinner or any volatile solvents to clean the
miter saw.
1. Carefully unpack the compound miter saw and all
its components.
2. Inspect the contents and compare to the list below.
1 Compound miter saw with laser line
assembly
2 Vise clamp knob
3 Dust bag
4 Miter handle
5 Blade wrench
6 Extension wings (2)
7 Bar holder clamp (4)
8 Stop bracket
Figure 2
2
1
Model 99192 shown
To Next Page
Loading...
