4. How to enter the settings page？
After installing the power supply and SD card, please turn the switch to "SETUP", You will enter the
Video Interface, you can press the "OK" button to test the resolution, or press the "MODE" key
continuously, You will see in turn
1. "Photo interface"-you can press the "OK" button to test the resolution, or press
the "MODE" button to agin into "File View" to view your pic/video
2. "File View"-used to browse the recorded files by "up" or "down" on the camera
3. "Settings page" Here you can use the "up", "down", and "OK" buttons to adjust
the camera settings, press "MODE" to exit
（Then turn the switch to "ON", the screen will go off after 5 seconds, and you will
enter the working mode, the camera will capture the animal pictures or videos
passing by the lens, if you want to exit the normal working mode, please switch to
"SETUP" or "OFF"）
To Next Page
Loading...
