5. Setting page details
1. [Mode] --select "photo" or "Video" or "Photo+Video", which means the camera is in the
"ON" state of recording mode
2. [Image size]-- select the photo resolution
3. [Picture No]-- can select the number of pictures taken at a time, press "OK" to confirm
(camera zai)
4. [Resolution] --select the resolution of the video and press "OK" to confirm
5. [Video Length] --select the video recording time
6. [PIR Interval] --selects the interval activation time of the sensor. The interval time you set
means the time required for the sensor to start the detection function for the second time.
During this interval, the sensor will not work, so your camera will not Record videos or pictures
during this process (Note: reasonable settings can avoid recording many pictures or videos in
the same event, reducing the memory from being filled up too quickly), “OK”button to enter,
"UP" or "Down" to adjust the value, "OK" button to switch min or sec, "MODE" button to exit to
the setting page
7. [PIR Sensitivity]-- Under normal circumstances, select "Medium", for indoor environments
and areas with less interference, please select "High", for environments where more
interference may cause a lot of memory, please select "Low"
To Next Page
Loading...
