SATA Mode Selection
Determines how SATA controller(s) operate.
Software Feature Mask Configuration
RAID OROM/RST driver will refer to the SWFM
configuration to enable or disable the storage
features.
Port 2-4
Enable or Disable SATA Port
Hot Plug
Designates this port as Hot Pluggable.
External SATA
External SATA Support.
Spin Up Device
On an edge detect from 0 to 1, the PCH starts a
COMRESET initialization sequence to the device.
SATA Device Type
Identify the SATA port is connected to Solid State
Drive or Hard Disk Drive.
Topology
Identify the SATA Topology if it is Default or ISATA or
Flex or DirectConnect or M2
Device Sleep
mSata for RTD3
SATA DEVSLEP Idle Timeout Config
Enable/Disable SATA DTIO Config
Info Report Configuration
Post Report
Post Report Support Enabled/Disabled
Info Error Message
Info Error Message Support Enabled/Disabled
Summary Screen
Summary Screen Support Enabled/Disabled
USB Configuration
Legacy USB Support
Enables Legacy USB support. AUTO option disables
legacy support if no USB devices are connected.
DISABLE option will keep USB devices available only
for EFI applications.
XHCI Hand-off
This is a workaround for OSes without XHCI hand-off
support. The XHCI ownership change should be
claimed by XHCI driver.
To Next Page
Loading...
