What to do if the on-line, paper status, error light is blinking and the Wincor Nixdorf Printer won’t print?
If the on-line, paper status, error light is blinking and the Wincor Nixdorf printer won’t print, it could be due to several reasons. First, ensure the receipt paper is properly loaded and all covers are closed. If the problem continues, contact a service representative.
What to do if the on-line, paper status, error light is blinking and the Wincor Nixdorf TH320 Printer won’t print because of temperature issues?
If the on-line, paper status, error light is blinking and the Wincor Nixdorf Printer won’t print due to temperature issues, the thermal print head temperature may be out of range, or the AC supply voltage may be out of range. If the print head is too hot, adjust the room temperature or move the printer to a cooler location. If overheating is due to printing high-density graphics continuously, reduce the demand on the printer. If paper is not low and no conditions indicate that the thermal print head is too hot, the power supply voltage is out of range. In that case, contact a service representative.
What to do if my Wincor Nixdorf Printer has power but doesn't print?
If your Wincor Nixdorf Printer has power but isn't printing, first check all cable connections to ensure they are properly connected. Make sure both the host computer and the power supply are turned on. Also, verify the DIP switch setting; DIP switch one should be off (up) for normal operation. If problems continue, contact a service representative.
How to fix Wincor Nixdorf Printer when receipt is not cut?
If the receipt is not being cut by your Wincor Nixdorf Printer, open the receipt cover and inspect the knife for any jammed paper. Clear any jammed paper that you find. If the problem persists, contact a service representative.
Why is the print light or spotty on my Wincor Nixdorf TH320 Printer?
If the print on your Wincor Nixdorf Printer is light or spotty, it could be due to a few reasons. First, check that the paper is loaded properly and that you are using recommended thermal receipt paper. You can also try cleaning the thermal printhead with an alcohol pen. Avoid using household cleaners as they can damage the printhead and electronics.
What to do if Wincor Nixdorf TH320 Printer starts to print, but stops while the receipt is being printed?
If your Wincor Nixdorf Printer starts printing a receipt but then stops, it's likely due to a paper jam. Open the receipt cover, inspect the knife, and clear any jammed paper.
Why are the forms printing light or spotty on my Wincor Nixdorf TH320?
If forms are printing light or spotty on your Wincor Nixdorf Printer, the form may not be inserted correctly. In this case, check 'Printing on forms or checks'. Other possible causes are a dirty or defective impact print head or improper platen gap. In these cases, contact a service representative. Another potential cause is a defective ribbon cassette. If so, see 'Installing or replacing the ribbon cassette'.
What to do if the receipt does not come out all the way from Wincor Nixdorf TH320 Printer?
If the receipt does not come out all the way from your Wincor Nixdorf Printer, it is likely due to a paper jam. Open the receipt cover, inspect the knife, and clear any jammed paper.
Why does my Wincor Nixdorf TH320 start to print, but stop while a form is being printed?
If your Wincor Nixdorf Printer starts to print but stops while a form is being printed, it could be due to a communication or software error. Check the interface cable and ensure the software is working properly.
Why do forms or checks skew or catch in the slip station of my Wincor Nixdorf TH320 Printer?
If forms or checks skew or catch in the slip station of your Wincor Nixdorf Printer, there may be an obstruction or paper jam in the slip station. Open the front cover and check for paper jams or other obstructions. Clear any jammed paper or obstructions.
General| Printing Method | Direct thermal |
|---|---|
| Paper Roll Diameter | Up to 83 mm |
| Power Supply | 24 V DC |
| Type | Thermal Printer |
| Print Technology | Thermal |
| Print Resolution | 203 dpi |
| Interface | USB, Ethernet |
To Next Page
