Why does my Windgoo Bicycle not work?
If your Windgoo Bicycle isn't working, several factors could be at play. It might be due to insufficient battery power, faulty connections, or the battery not being fully seated in the tray. Also, check for an improper turn-on sequence, engaged brakes, or a blown discharge fuse. In any of these cases, repair or reconnect the relevant components.
Why does my Windgoo E20 Bicycle have irregular acceleration and/or reduced top speed?
There are several reasons why your Windgoo Bicycle might have irregular acceleration or reduced top speed. The possible causes are: insufficient battery power, loose or damaged throttle, and misaligned or damaged magnet ring. If the battery is the problem, tighten or replace it. If the throttle is loose or damaged, tighten or replace it. If the magnet ring is misaligned or damaged, secure or replace it.
What to do if the motor does not respond when Windgoo E20 Bicycle is powered on?
If your Windgoo Bicycle motor isn't responding when powered on, it could be due to loose wiring, a loose or damaged throttle, or a loose or damaged motor plug wire. In the case of loose wiring, adjust the connections. If the throttle or motor plug wire is loose or damaged, replace them. A damaged motor can also be the cause, and in that case, repair or replace it.
Why does my Windgoo E20 wheel or motor make strange noises?
If your Windgoo Bicycle wheel or motor is making strange noises, it could be due to low tire pressure (adjust tire pressure), a low or faulty battery (check connections or charge battery), or driving with too many hills, headwind, braking, and/or excessive load (assist with pedals or adjust route). It may also be caused by a battery discharged for a long period of time without regular charges, or the battery is aged, damaged, or unbalanced (balance the battery; contact tech support if range decline persists). Brakes rubbing can also cause noise (adjust the brakes).
Details the various parts of the electric bike with a visual diagram for identification.
Explains how to enter and navigate the bike's setting menu for customization.
Guides on changing the speed display unit between KM/H and MPH.
Details the process for adjusting the wheel diameter setting for accurate measurements.
Provides instructions on cleaning the bike and recommended storage conditions.
To Next Page
General