Windgoo E20 - Start-up Procedure; Remove the Battery

06
Start-up procedure
After the bike has been properly assembled according to the assembly video, all components
are secured correctly, a certified, reputable mechanic has checked the assembly, and you
have read this entire manual, turn on the bike and select a pedal assist level following the
steps below:
1. Test the battery lock security.Ensure the key port is aligned with the OFF icon, which
indicating the battery is off and locked onto the frame mount.Carefully use both hands to pull
up on the battery to test that the lock is secure.
2. Ensure proper handlebar and seat adjustment. Note that lowering the seat so the rider
can put one or both feet flat on the ground without dismounting from the seat may offer a
safer and more comfortable introduction to operating the bike.Ensure the handlebar
faceplate bolts and seatpost quick release are fully and properly secured.
3. Turn the bike on/off.Insert the key and turn clockwise to the ON position.Locate the LCD
Display (near the left handlebar grip).Press and hold the center power button "M for approx-
imately 3 seconds to turn onloff the bike.
4. Front light:Long press the "+" button to turn onloff the front light.
5. Select the desired level of pedal assistance (PAS) between level 0 through 3 using the +
and- on the display remote. Level 1 corresponds to the lowest level of pedal assistance, and
level 3 corresponds to the highest level of pedal assistance.Level 0 indicates pedal assistance
is inactive. Start in PAS level 0 or 1 and adjust from there.
6. Begin riding carefully. With the proper safety gear and rider knowledge, you may now
operate your bike. On a flat surface, in a low gear (1 or 2), most riders should be able to
begin pedaling the bike with pedal assist level 0 or 1.You may also use the throttle to
accelerate and maintain your desired speed.
7. The throttle is used by slowly and carefully press the throttle downward. Do not use the
throttle unless you are on the bike.
Do not use the throttle while dismounted.Avoid accidental application of the throttle
while dismounted; anytime you are moving the bike while dismounted, ensure the
bike is powered off to prevent accidental application of the throttle.
NOTICE: You have to press the key then you can switch to unlock position.
Remove the battery
For your convenience, the bike battery can be removed.
Locate the seat quick
release lever and turn
over the saddle.
Press and rotate the key to
the UNLOCK icon.
Carefully slide the battery
upwards and lift it off the
frame.